...
View file | ||||
---|---|---|---|---|
|
BOM:
View file
RE606_BOM.v1.3.2-RLS.xlsx (latest version with mouser part numbers)
mouser card: (not approved from me)
...
- The jumper wire strip from the alpha BOM was slightly too short, looks like it was updated in the latest BOM to 3 inch, but I would recommend maybe even getting the 4inch instead of 3inch :
- 571-FSN-23A-8 (Mouser)
- The scale switch - while this is by no means correct, this will work - just need to wire it to the board, and its quite small compared to the hole in the cases etc
- 611-SS-24E06-TG5P (Mouser)
BOM help:
Fuse Resistor 2.7ohm = R237 in PSU:
Mouser: PR02FS0202708KR500
TME: NFR1W-2R7
Tipps:
in case you dont have the SCALE Switch and want test the RE606 with a Workaround (Bridge Pins instead of a Switch)
, you have to Bridge the switchchassis holes with a cable at the outer mounting holes (same in Re303 ) - otherwise the GND pads/traces of the Instruments are not connected
Discussion about the Scale switch: http://23.235.199.139/~re303c5/forum/topic/514-unobtainium-re606-pre-scale-switch/?tab=comments#comment-12104
Issues:
please respect on the switchboard D404 is in wrong orientation, as described in the BOM
...