Versions Compared

Old Version 47

changes.mady.by.user LED-man

Saved on

compared with

New Version 48

changes.mady.by.user LED-man

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Expand
titleKnown Issues Click here to expand...
  1. Major Bug: Description:  at the Frontpanel pcb side you find some "VIAs", at the VCO 3 section the jack S/H , VCO2 section the jack ADSR, VCA section the jack Ringmod, has a via with 15V, the metalcase of the jack is connected to ground and you run in a short between ground from the jack and 15V from the via, there are 2-4 other jacks with vias too (i report asap all related jacks today evening) (tick)
    Solution file down the jack at the position of the via (1mm is fine)
     Image Added

  2. Improvement: Powersupply Board - turn the 2pol MTA156 header if needed - otherwise the power input cable is above the powersupply.   (tick) confirmed

  3. Minor Bug:Main board – Missing trace from V- to header. (copyright of picture for thehumancomparator.net ) (tick) confirmed


  4. Minor Bug: 4072 VCF missing trace pin 4 on LM1458 to -14V (use shrink tube for isolation) (tick) confirmed


  5. Minor Bug: 4012 VCF Board — BC558 must be installed backwards, schematics show Ermitter to 23k2 resistor in rev.7.2 (v2) (tick) confirmed


  6. Minor Bug: for all 2N3958 and 2N3954 change 2 pins like this,  cross the both pins - use shrink tubing for one pin for isolation. (tick) confirmed


  7. Improvement for build: or the Filtercards use flat electrolyte capacitors, check the hight of all parts - if needed use other headers, check this for both Filtercards before you solder the headers, if needed place the 47pf(50pf) MLCC capacitor (on the mainboard) on solderside of the pcb)
    on my first build i used a 10mm spacer but i prefer the usage of 12mm spacers,  (by usage of 2 spacers - its needed to cut on the VCF out jack at the bottom some metal and you need a flat screw,  in result one spacer is enough  (wink) )


  8. Minor Bug: by usage of the banzai reverb tank, run in the reverb tabk a wire from ground to ground on the RCA connectors to ground output and input

  9. Minor Bug: turn 180degrees on the mainboard the 5pol MTA156 powerheader, otherwise the powercable is to the wrong side.

...