...
I bought the kit without the X-Y-Z PCB (because I left one assembled and tested PCB set from a cloney)
Issue ID | Date | Location | Type | Identified issue | Resolution | related for development | affected PCB version | fixed Version |
---|---|---|---|---|---|---|---|---|
1 | 20.july 2023 | SynthiA | bug | the X card is in contact with the speaker | options: A: use a other speaker or B: use a Dremel and cut the pcb C: wide the holes that the pcb is in other place | rev1 Synthey from 2023 | ||
2 | 20 july | keybed | tip | decals | use water while placing the decal on the pcb and the case | make a note in the guides | ||
3 | 20 july | keybed | info | CN3 clock LED info | "This LED is just an option Because EMS did not provide any power LED nor a clock LED on the KS there is no hole for an LED on the DKS case. | |||
4 | 20 july | synthiA | critical bug | the Screw is 11mm instead of 10mm and touch the transformer | use a 10mm screw or mount the transformer on a other place or use a other transformer (torradial ) | |||
5 | 20 july | keybed | warning | make sure you solder carefully the LED - otherwise it can happen you have a short there: | in case you get too close or in contact with the "metal ring" you can use a Dremel and cut the metal ring as your needs | |||
6 | 20 July | keybed | info | its just a info from a user who used a header/cable for the LED | ||||
7 | 20 july | SynthiA | info | about the panel screws: the screws within the DIN 7991 / DIN EN ISO 10642 |